Replacing The Lamp - Heatsail BEEM 230 Manuel De L'utilisateur

EN

3.2. Replacing the lamp

Your BEEM is supplied with 6 (BEEM 230, BEEM 290) or met 8 (BEEM 390,
BEEM 520) G9 halogen bulbs of 230V max 40 Watt as standard. The max-
imum permitted output power is 240 Watt.
The electrical supply must be disconnected via the installation's breaker
switch before the bulb can be replaced.
You can replace the bulb by carefully lifting up the glass panel and remove
it by turning it. The bulb is held in place by a spring. Remove the bulb by
pulling gently to release it from the holder. Then replace the bulb and re-
verse previous steps.
Please note: Be careful never to touch the halogen bulb with bare fingers,
as oils from skin will significantly reduce bulb life.
3.3. Inspection
The BEEM must be subjected to an annual inspection.
The user is not authorized to carry out his own inspections and repairs.
Inspection of the BEEM must exclusively be carried out by qualified and
authorized technicians, in accordance with Heatsail's applicable standards
and regulations. "Qualified technicians" are understood to mean: people
who have completed a technical training course for the installation of
outdoor heating and who are familiar with the applicable electrical laws
and regulations.
The electrical supply must be disconnected via the installation's mains
breaker before any work can be carried out.
All repairs must be requested via Heatsail or an authorized distributor of
Heatsail products. A repair is only valid when original parts have been
used.
Upon written approval by Heatsail, the entire control panel should be re-
turned in case of a defective cable.
Heatsail will not be held responsible for damage resulting from non-
compliance with the maintenance instructions.
User manual 31