Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
First use
Never exceed the maximum permissible input values.
Before measuring, remove the cover of the test lead and switch on the multimeter by pressing the
on/off button [10]. The multimeter has an auto power OFF function and switches itself off
automatically after longer periods of non-use. However, you can also switch off the multimeter
directly with the on/off button [10].
You obtain a more accurate measurement result if you use the smallest possible measuring
range.
Overflow indicator
The multimeter has an overflow indicator. If a measured value exceeds the range limit of the
selected measuring range, "0L" is indicated on the display [1]. In this case, switch to a higher
measuring range immediately if possible, or remove the test probes [7] from the test object.
DC voltage measurement
Connect the black test lead to the COM jack [5] and the red test lead to the V jack [6].
Set the range selector switch [4] to the desired range in the DC voltage measuring range
V
.
If you do not know the voltage, first set the highest possible measuring range and then
reduce it gradually to the lower ranges until you obtain a satisfactory measurement result.
Connect the test probes [7] to the test object.
The measurement result is then indicated on the display [1]. A negative sign is indicated in
front of the measured value for a negative measurement result.
AC voltage measurement
Connect the black test lead to the COM jack [5] and the red test lead to the V jack [6].
Set the range selector switch [4] to the desired range in the AC voltage measuring range V
If you do not know the voltage, first set the highest possible measuring range and then
reduce it gradually to the lower ranges until you obtain a satisfactory measurement result.
Connect the test probes [7] to the test object.
The measurement result is then indicated on the display [1].
POWERFIX PDM 300 A1
English - 45
.
~
Publicité
Chapitres
Table des Matières
