Maxima MAX-OXY Instructions D'installation & Emploi page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

HOLIDAY MODE
It is possible to put the appliance in holiday mode; this will
prevent automatic regeneration from taking place, yet will
ensure the appliance is automatically regenerated at the end
of the holiday cycle.
1. Press the scroll
button repeatedly until the display
shows:
Holiday: OFF
Press the up
or down
holiday mode by setting the number of full days away
from home, or deactivate the holiday mode (OFF).
Once the control panel is back in service mode, the display
will show:
8:01
Holiday
The holiday mode is automatically cancelled when a
regeneration is manually initiated!
PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS
Before entering the programming mode, make sure that
the appliance is in service mode.
In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1. Press the scroll
button and hold it for 2 sec until the
display shows:
Language:English
Press the up
or down
language.
2. Press the scroll
button again; the display will show:
Set time:
Press the up
or down
day.
3. Press the scroll
button again; the display will show:
Rech. daily: ON
Press the up
activate/deactivate the daily recharge of the
compressed air chamber.
ELECTRONIC CONTROL PANEL
button to activate the
button to set the
8:01
button to set the time of
or down
button to
4. Press the scroll
Interval:4 Days
Press the up
of days between regenerations.
5. Press the scroll
Buzzer: ON
Press the up
disable the buzzer.
6. Press the scroll
Exit
Press the up
into the NOVRAM® and exit the programming mode.
The filtration capacity of the appliance mainly depends
on the daily water usage and the iron/manganese content
in the water; many other factors may also have a significant
impact on the filtration capacity. Therefore it is
recommended to regenerate the appliance on a regular time
basis. In most applications a regeneration every 3 to 4 days
should be sufficient.
In case of excessive:
iron/manganese content,
­
water consumption,
­
amounts of organic matter or suspended solids,
­
it is recommended to lower the regeneration interval to 1 or
max. 2 days.
Page 9
button again; the display will show:
or down
button to set the number
button again; the display will show:
or down
button to enable or
button again; the display will show:
or down
button to save the settings
EN - English

Publicité

Table des Matières
loading

Table des Matières