Power Supply - Silverline A-REPELLER KV300 Mode D'emploi

EN
Location
Place the repeller 20-60 cm above the ground. Use the included pole or mount the repeller on a fence or
wall. The motion sensor and sound work best horizontally levelled. Therefore the repeller should be placed
at the same height as the actual animal to be repelled. Do not direct the repeller against the ground. Place
the repeller so it will cover the area that should be guarded. Be sure to keep the area free from obstacles
since the sound does not penetrate solid materials. Select appropriate frequency using the selection knob.
If no immediate effect is noticed, a first recommendation is to change frequency and secondly to move the
repeller.
To increase the effect when repelling cats it is recommended to move the unit each week in the beginning.
Direct against the same area but from different places. The cats will change their behaviour after some weeks
and the intervals between moving the repeller can be extended.
Large gardens might need more than one repeller to cover the areas.
Cover area for the motion sensor
1-15 m
This assignment is a reference. Weather conditions and obstacles may affect the guarded area.
Avoid exposing the motion sensor to direct sunlight, since this could shorten the lifetime.
Detecting area
Frequency selector
Turn the knob to set the desired frequency.
1. Cat
2. Cat/Dog
Off
3. Dog/Small animals
4. Small animals

Power supply

Battery operated
1. Unscrew the lid at the bottom of KV300.
2. Insert 6 LR14 batteries (not included), with correct polarity according to the guidance in the battery casing.
3. Mount the protection lid back on.
4. Turn the frequency selection knob to any position and test the function. The blue LED indicator should now
light up. When the motion sensor detects a movement the white repelling light and the repelling sound should
be activated.
Transformer (not included) DC 12V, at least 200 mA contact device type E:
1. Connect the transformer contact to the DC 12V connection.
2. Plug the transformer into a 230V wall socket.
3. Turn the frequency selection knob to any position and test the function. The blue LED indicator should now
light up. When the motion sensor detects a movement the white repelling light and the repelling sound should
be activated.
KV300
Art.nr 25360
Manufacturer: Miljöcenter AB, Sweden
www.silverline.se
For optimum use, visit www.silverline.se
for advice and tip.
2
300m
Ultrasound
Pest Protect system
1-15 m
20-60 cm
Detecting area Above ground
LR14 4 months
x6
Battery life
Alkaline battery
®
IP
44
Ingress Protection
Audible
17