Instructions For Ph5 / Cond5 / Pc5; Power On; Setup Menu For Ph5 / Cond5 / Pc5; Measurement - LABBOX 1 Série Mode D'emploi

INSTRUCTIONS FOR pH5 / Cond5 / PC5

POWER ON

Press key once, the meter will switch On and performs a test of 3 colors backlight display and then show
all the segments active for 2 sec.
Then it will display the following:
ORP
pH SAL
KΩ MΩ
COND
RES TDS mg/L ppm ppt
%
-18.8.8 pC 5
µS
mS
pH
mV
°C
HOLD 18.8.8
°F

L M H

SETUP MENU for pH5 / Cond5 / PC5

1. With meter switched off, press and hold
2. The meter will switch on with all the segments active, release
Setup Menu (green backlight during setup).
3. Press key to select the parameter to be changed between:
Function
Temperature unit (°C/°F)
Reference temperature for conductivity
Coefficient for temperature compensation
TDS factor
Reset to factory default
4. Press to enable the value changing of the selected parameter.
5. The value of selected parameter will start flashing.
6. Press to change the value and then press
7. The value stops flashing.
8. Press to select other parameters or press
NOTE: Any time press ESC

MEASUREMENT

Rinse the electrode with distilled water or sample prior to start measurement.
Fill the measuring cap with sample, switch on the meter with
parameter to be measured (green backlight during measurement).
Immerse the Tester in sample and wait for stability, when stability icon ☺ appears on display take the
reading.
During measurement make sure that pH electrode is free from air bubbles, and that there isn't any air
bubble around or between conductivity sensor.
Waterproof tester series
COND
trE
°C
r 1.0 25

CAL
ORP pH
RES COND
-18.8.8
HOLD
L M H
Primary display
key to exit from SETUP menu.
COND
%
2.0
tCC
°C
 
key and press key once.
CAL key, the meter will go into the
SAL
KΩ MΩ
mg/L ppm ppt
TDS
%
µS
mS
pH
mV
18.8.8
°C
°F
Secondary display
t.U
trE 20 - 25 °C
0...4 %/°C tCC
0.40 - 1.00 Fct
nO - YES rSt
to confirm.
ESC to exit the setup menu.
and press MODE
pH
TDS
0.7 1 4.0 1
fct 23.5

L M H
Primary display
Secondary display
Default value
- °C
25°C
1.9
0.71
nO
key to select desired
pH
°C
7