Instructions For Ph1 / Cond1; Power On; Power Off; Setup Menu For Ph1 / Cond1 - LABBOX 1 Série Mode D'emploi

INSTRUCTIONS FOR pH1 / Cond1

POWER ON

Press key once, the meter will switch On and the display will show all the segments active for 2 sec. and
then it will display the following:
ORP pH SAL
KΩ MΩ
RES COND TDS mg/L ppm ppt
%
-18.8.8 pH 1
µS
mS
pH
mV
18.8.8 °C
HOLD
°F

L M H
All segments ON -> model name + software release -> measurement

POWER OFF

To turn off the meter press

SETUP MENU for pH1 / Cond1

1. With meter switched off, press and hold
2. The meter will switch on with all the segments active, release
into the Setup Menu.
3. The display will show SLT on primary display with
4. Press to select the parameter between
press to confirm (Only for Cond1).
o Only if the
change this factor and then press
5. The display will show rSt (RESET):
6. Press and select
7. At this point the meter finishes SETUP menu and switches off.
NOTE: To skip the changing of the value simply confirm the flashing value with
will go to the next Parameter.

MEASUREMENT

Rinse the electrode with distilled water or sample prior to start measurement.
Fill the measuring cap with sample, switch on the meter with , immerse the Tester in sample and wait for
stability, when stability icon ☺ appears on display take the reading.
During measurement make sure that pH electrode membrane is free from air bubbles, and that there isn't
any air bubble around or between conductivity sensor.
Waterproof tester series
pH
4.0
pH
r 1.0

key for 3 seconds, the meter will switch off.
CAL
COND
TDS is selected then the display will show TDS Fct flashing, press to
nO flashing.
YES if a reset of the meter is required and then press
key and press key once.
CAL key, the meter will go
COND flashing (only for Cond1).
or TDS to be used for measurements and
to confirm (Only for Cond1).
COND
SLT
TDS
0.7 1
to confirm.
key, the meter
No
fct
rst
5