Installing And Assembling; Installation; Connections; Configuration - Videotec TWM2 Manuel D'instructions

6 Installing and assembling

h Only specialised personnel should be
allowed to install and assemble the device.

6.1 Installation

6.1.1 Connections

h To make the connections just follow
the arrangement given in the table
below which, for each model, shows
the connector to be used according to
the type of device to be connected.
CONNECTIONS TABLE
TWP BNC
TWM2 BNC
TWT2 GND |
VIDEO IN
TWT2A GND |
VIDEO IN
TWRB2 ---
TWRR2* ---
TWRB2A ---
Tab. 01 * In the TWRR2 receiver the connectors
are on the back of the rack.
--- A B ---
--- A B AC / DC
--- A B AC / DC
--- A B L N
GND | A B AC / DC
VIDEO
OUT
VIDEO A B POWER
OUT SUPPLY
GND | A B L N
VIDEO
OUT

6.2 Configuration

When configuring the TWT2A and TWRB2A
g
models take particular care to prevent
accidental contact between the tool being
used for regulation and the live parts
(230Vac), since the device must be powered
when carrying out the adjustments.
The configuration procedure makes it
h
possible to set up the unit for optimum
performance and should only be carried
out by skilled, authorised personnel.

6.2.1 Transmitters

Fig. 01 TWT2A.
Fig. 02
TWT2.
7