hestan GABR CX2 Serie Manuel D'utilisation Et D'entretien page 32

CLEANING AND MAINTENANCE
LIGHT BULB REPLACEMENT LIGHT BULB REPLACEMENT
1. Disconnect the power to your grill before any service or light bulb replacement. Be sure the
grill and the lights are completely cool. Halogen lights get extremely hot.
EN
2. Open hood and remove the small screw holding the lamp assembly in place (Fig. 10). Remove
the lamp assembly, being careful not to drop the glass lens.
3. If needed, use a small flat-blade screwdriver to carefully pry off the lens and set aside. Loosen
the 2 screws closest to the lamp housing (Fig. 11). These screws hold the bulb in place. The
bulb should come out easily. The bulb is a 20W halogen "Bi-Pin" type, available at most
hardware stores & home centers.
4. Before installation, it is very important to clean the new bulb carefully with a clean, soft cloth,
or tissue paper. Grease, fingerprints, or oils in your skin can leave a residue on the glass surface
of the bulb which will create a hot-spot. The bulb will eventually crack at this hot-spot.
5. While still using a cloth or tissue paper, install the new bulb in the housing and tighten the
screws. Check that the other tiny screws are tight as well.
6. Re-install the lens and return the lamp assembly to the hood. Carefully install the screw to
secure the assembly to the hood.
CARE & MAINTENANCE OF SIDE BURNER COMPONENTS
SIDE BURNER GRATE SIDE BURNER GRATE
The easiest way to clean the cooking grate is immediately after cooking is completed and after
turning off the flame. Wear a grill mitt to protect your hand from the heat and steam. Dip a brass
bristle grill brush in hot soapy water and scrub the hot grate. Dip the brush frequently in the
bowl of water. The steam created as water contacts the hot grate, assists the cleaning process by
softening any food particles. If the Side Burner is allowed to cool before cleaning, then cleaning
will be more difficult.
BURNER CLEANING BURNER CLEANING
Cleaning of the burner assembly itself should only be necessary in the event of a large spillover
which may have clogged the burner ports, etc. When the burner is completely cooled down,
remove the burner cap and clean up whatever debris, food, grease etc. you find using a warm, soapy
water solution. A toothbrush can be used to scrub difficult areas. Wipe with a clean cloth and
reassemble.
IGNITERS IGNITERS
The spark igniter on the Side Burner is partially exposed and can be contaminated in the event
you have a boil-over when using the Side Burner. You can gently clean them with a soapy water
solution and a toothbrush. Wipe down with a clean cloth.
NOTE: Rough handling of the igniter can crack the ceramic body, causing it to fail. Handle with NOTE:
care.
30
©2021 Hestan Commercial Corporation
Figure 10
(continued)
Figure 11