hestan GABR CX2 Serie Manuel D'utilisation Et D'entretien page 25

LIGHTING INSTRUCTIONS
(continued)
LIGHTING SIDE BURNERS
1. Remove cover during lighting.
EN
2. Stand as far away as possible when lighting.
3. Push and turn selected knob to "HIGH" position. Igniter will spark until flame is established.
4. Once lit, turn knob to desired flame setting. If spark does not occur, check electrical supply.
5. If burner does not light in 5 seconds, turn knob to "OFF" and wait 5 minutes before re-lighting.
6. If burner fails to light, see match lighting instructions below.
Note: Note: The flame-sensing technology of the spark igniter will repeatedly spark (clicking sound) until
a flame is established. If you experience nuisance sparking during normal operation of the burner,
see the TROUBLESHOOTING section of this manual. A very low flame in windy conditions is
usually the cause of this nuisance sparking.
MATCH LIGHTING INSTRUCTIONS
If a burner will not light after several attempts, it can be lit with a match. Open the hood and allow
5 minutes for any accumulated gas to dissipate from the grill. Use a long-stem fireplace match, or
attach a short match to the match lighting clip provided with your Hestan Grill
(see below Fig. 7).
Figure 7
When attempting to light a burner with a match, be sure you selected the correct control knob for
that burner. Keep your face away as far as possible, and pass the lit match through the openings of
the cooking grates and radiant trays and position near the burner ports. Push and turn the control
knob to "HIGH" until the burner lights. Repeat this procedure for each burner if necessary. If
the burner does not light in 5 seconds, turn the control knob to "OFF" and wait 5 minutes before
trying again. If the burner will not light after several attempts, see the TROUBLESHOOTING
section of this manual. Side burners can be lit in the same manner, although a long match may not
be needed.
In sunny locations, infrared Rotisserie and Sear Burners may be difficult to see if they are lit. After
attempting to light, you can very carefully wave your hand 8-10 inches [20-25 cm] away from the
burner surface to feel the heat of the burner. If there is no heat, OR IF YOU SMELL GAS, shut off
the control knob and wait 5 minutes before attempting to re-light.
23
©2021 Hestan Commercial Corporation