Kobalt K18-MC45A Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY INFORMATION
f ) Keep the cord and charger away from heat to prevent
damage to the housing or internal parts.
g) Do not allow gasoline, oils, petroleum-based products, etc.
to come in contact with plastic parts. These materials contain
chemicals that can damage, weaken, or destroy plastic.
h) An extension cord should not be used unless absolutely
necessary. Use of an improper extension cord could result
in a risk of fire and electric shock. If an extension cord
must be used, make sure that:
The pins on the plug of extension cord are the same number, size
and shape as those of the plug on charger.
The cord is properly wired and in good electrical condition
The size is large enough for
specified below:
Cord Length (Feet)
Cord Size (AWG)
NOTE: AWG = American Wire Gauge
i) Do not operate the charger with a damaged cord or plug,
which could cause shorting and electric shock. If damaged,
have the charger repaired or replaced by an authorized
service technician.
j) Do not operate the charger if it has received a sharp blow,
been dropped, or has otherwise been damaged in any way.
Take it to an authorized service technician for an electrical
check to determine if the charger is in good working order.
k) Do not disassemble the charger. Take it to an authorized
service technician when service or repair is required.
Incorrect reassembly may result in a risk of electric shock
or fire.
A/C
ampere rating of charger as
25
ft.
50
16
16
9
ft.
100
ft.
16

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

0352551

Table des Matières