Assembly Instruction - Viscount YP200 Manuel Du Propriétaire

1) Make sure you have the following parts, which are supplied in the package:
A) Piano cabinet
B) Right Leg
C) Left Leg
D) Rear Panel
E) Bottom crossbar with three pedals group
F) Pedal clog
G) Headphone hang
and the fixing accessories to be found into a nylon bag:
H) M6x20 TC screw (2x)
I) M6x20 TC screws (8x)
L) WL 4x20 TC screw (4x)
M) WL 4x12 TC screw (2x)
N) Adhesive clamp (5x)
O) Phillips screwdriver
2) Remove the nylon protection and white foam on the wooden parts, free the pedals cable
under the crossbar as shown in Fig. 3
3) Fix on pedals group the pedal clog (F) as shown in Fig.1.
4) Fix the right leg (B) to crossbar (E) with screws (I).
5) Fix the left leg (C) to crossbar (E) with screws (I).
6) Fix the rear panel (D) to the crossbar (E) with screws (L) and to the legs (B) and (C) with
screws (H) as shown in Fig.1.
7) Place the piano cabinet (A) on stand, fix it with screws (I) as shown in Fig.1
by paying particular attention to the position of the hook, as shown in Fig.2.
8) Fix the headphone hang (G) whit screws (M) as Fig. 1
9) Attach the adhesive clamps (N) as shown in Fig.4
10) Insert the MINI DIN pedals cable plug into the proper socket of I/O group under the
pianocabinet (A) and fix the cable on the adhesive clamp (N) of Fig. 4.
11) Place the piano in its final location and adjust on floor the clog (F) of pedals group.

Assembly instruction