Backup; Help; Standby - Viscount YP200 Manuel Du Propriétaire

owner's manual

BACKUP

This function sets the YP200 starting mode:
Mode 1: YP200 load the factory set.
Mode 2: YP200 loads the user set.
Keep the Backup Function Key (A7) pressed
and press the DATA button on the panel. The
vocal guide signals the
active BACKUP status.
To change the Backup status, keep
the BACKUP Function Key pressed then
use the DATA buttons on the panel to
modify the value. The vocal guide
signals backup status (BACKUP ON or
OFF).
The default value is: BACKUP OFF
(YP200 load the factory set).

HELP

This function allows you to enable or disable the
voice guide. The voice guide help you to easily
setup the functions of YP200.
To change the HELP status, keep HELP Function
Key pressed and press the DATA buttons on the
panel. The vocal guide signals help status (HELP
ON or OFF). Default value is HELP ON.
Simultaneously pressing DATA UP and
DATA DOWN will be set to the default
value (HELP: ON).
To exit the HELP function you must
release the Function Key B7; the last
value will be stored.

STANDBY

It allows to permute YP200 automatically in low-
power mode after 30 minutes of inactivity. To
change the value, press and hold the button (C8),
then using the DATA UP and DATA DOWN, YP200
will declaim the new value:
1. STANDBY ON (default): Automatic low-
power switched on
2. STANDBY OFF: Automatic low-power
switched off
Simultaneously pressing DATA UP and DATA DOWN
will be recalled the default value (STANDBY ON).
To exit Standby function is necessary to release the Function Key C8, the
last value will be stored.
touch tune temper. time s. effects
touch tune temper. time s. effects
touch tune temper. time s. effects
YP200
maf eq midi backup help standby
maf eq midi backup help standby
maf eq midi backup help standby
EN - 8