Bosch TASSIMO TAS 55 GB/CH Série Mode D'emploi page 5

en
5.
Activate BRITA Filter cartridge replace
indicator
For maximum fi lter performance and anti­
scale protection, the BRITA MAXTRA fi lter
cartridge (5d) should be replaced every
eight weeks.
The BRITA cartridge replacement indicator
(3f) on the top of the machine uses bars to
indicate when the fi lter cartridge (5d) should
be replaced with a new one.
To activate the BRITA fi lter cartridge replace­
ment indicator (3f), press and hold the Start
button until all four bars appear on the dis­
play and blink twice.
The blinking dot in the lower right corner
indicates that the fi lter cartridge replace­
ment indicator (3f) is activated. All four bars
should be visible.
TAS55_GB-CH.indb 7
5. Now place the fi lter cartridge holder
(5c) with the fi lter cartridge (5d) into the
empty water tank and fi ll the tank with
fresh water to the max mark.
! Important:
Always remove the fi lter cartridge
holder (5c) with the fi lter cartridge
(5d) before running the descaling
programme.
From this moment on, one bar disappears
every two weeks. When no bars are visible
after eight weeks and the arrow is blinking,
replace the fi lter cartridge (5d).
To remove the fi lter cartridge (5d), simply
pull it out by its tab.
To prepare a new fi lter cartridge (5d),
follow the instructions in the section titled
"Preparing and inserting BRITA MAXTRA
fi lter cartridge" and reset the BRITA fi lter
cartridge replacement indicator (3f), by
pressing and holding the Start button.
i ¡
Note:
Your TASSIMO machine is now ready for
use.
i ¡
Note:
It's a good idea to purchase a new fi lter
cartridge (5d) when the replacement
indicator shows only one bar. BRITA
MAXTRA fi lter cartridges (5d) are available
from various retailers or directly from the
Bosch Customer Service Department (see
page 75 for contact information).
7
01/2013
11.01.2013 15:09:53