Caution
-
Never immerse the cleaning system or the charging stand in water and
do not rinse it under the tap.
-
Never immerse the shaver in water. Do not use the shaver in the bath
or in the shower.
-
Never use water hotter than 80°C to rinse the shaver.
-
Only use this appliance for its intended purpose as shown in the
user manual.
For hygienic reasons, the appliance should only be used by one person.
-
Never use compressed air, scouring pads, abrasive cleaning agents or
-
aggressive liquids such as petrol or acetone to clean the appliance.
If your shaver comes with a cleaning system, always use the original
-
Philips cleaning luid (cartridge or bottle, depending on the type of
cleaning system).
Always place the cleaning system on a stable, level and horizontal
-
surface to prevent leakage.
If your cleaning system uses a cleaning cartridge, always make sure
-
that the cartridge compartment is closed before you use the cleaning
system to clean or charge the shaver.
When the cleaning system is ready for use, do not move it to prevent
-
leakage of cleaning luid.
-
Water may drip from the socket at the bottom of the shaver when
you rinse it. This is normal and not dangerous because all electronics
are enclosed in a sealed power unit inside the shaver.
Electromagnetic ields (EMF)
-
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic ields.
General
-
This shaver can be safely cleaned under the tap.
-
The appliance is suitable for mains voltages ranging from 100 to 240 volts.
-
The adapter transforms 100-240 volts to a safe low voltage of less than
24 volts.
Charging
It takes approx. 1 hour to fully charge the shaver.
When you charge the shaver for the irst time or after a long period of
disuse, let it charge until the white battery lights up continuously.
A fully charged shaver provides up to 60 shaving minutes.
The shaving time may be less than 60 shaving minutes as a result of your
shaving behaviour, your cleaning habits or your beard type.
ENGLISH
7