Feet; The Handle Installing; To Remove A Shelf; Electrical Connection - CASO DESIGN Barbecue Cooler R Mode D'emploi

• The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
• For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
13.5.2

Feet

There are different feet (3 bigger feet and 1 small foot).
To level your appliance, adjust the small foot at the bottom of the appliance.
13.5.1

The handle installing

The wine cooler comes with one metal
stainless steel handle. To install simply
screw them to the door with the supplied
screws.
To do this, slide the rubber seal on the back
of the door to the side to lay open the
predrilled holes. Use the included screws to
install the handle on the door.
Then reinsert the rubber seal in the correct
position.
13.5.2

To remove a shelf

Remove all bottles from the shelves. Lift the
shelf upwards and the gently pull it out,
(eventually untighten the screws).
Please note
► Ensure that the shelves are firmly engaged in place before storing any bottles.
► Pay attention for a uniform disposition of the bottles in the device.

13.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
30