Disposal Of The Packaging; Setup; Setup Location Requirements - CASO DESIGN Barbecue Cooler R Mode D'emploi

• After at least 24 hours, plugging the appliance into the wall outlet, than place wine
bottles or beverages in the appliance.
Please note
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.

13.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste.
Take any packaging materials that are no longer required to "Green Dot" recycling
collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.

13.5 Setup

13.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
• Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
• Ambient temperature below 16°C or above 38°C will hinder the performance of the
appliance.
• This unit is designed only for the protected outdoor area. Do not place it in a wet or very
moist environment. The device complies with the International protection rating IPX4
(offers protection from a splash of water in any direction). Protect the device from the
weather conditions and frost.
• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
• The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the appliance. This is not the case if you use the cabinet
which is developed by CASO (681, 682).
• WARNING! Do not close the ventilation openings in the device housing.
29