CDVI V3SR Mode D'emploi page 3

PRODUCT PRESENTATION
Monitored
Surface mount
High Corrosion resistance
Safety Rope
Delivered with armature
No mechanical wear
Ease of installation
Recommended for interior use
Fail safe (Door unlocked when power off)
Holding force: 300 kg
No residual magnetism
Visual signalling (Blue = Locked ; Green = Open)
Built-in varistor: Built-in electronic protection
to eliminate back EMF
Dimensions (L x W x D): 254 x 45 x 27mm
Armature dimensions (L x W x D): 185 x 38 x 11mm
Power supply: 12/24V dc
Power absorption: 12 V DC = 510mA
24 V DC = 270mA
WEEE & RoHS
The V3SR is suitable for the new
EC certification
regulations covering assistance to
IP42
PACKAGE CONTENTS
Armature
Magnetic lock
plate
1 1
Rubber
Steel washer M8x35 screw
washer
2 1
ELECTRICAL CONNECTIONS
12V dc default setup
Terminal
Correspondence
block
+ 12 or 24V dc
- - 0 V
NO Normally open
C COM
NC
Normally closed
The N.O./N.C. signal only switches when the door is
closed and electromagnetic lock powered.
IMPORTANT NOTE
Specifications :
Check the jumper position before connecting the
- Epoxy 1,6mm
lock to the input current. A wrong position could
- Class 4
damage the lock. This type of damage is not
- PCBoard with 4 layers
covered by the warranty.
- Metallized holes
- Cooper 35µm for all layers
- Chemical finishing Nickel/Gold
(Nickel 5µm ; Gold 0,05 µm)
- Green solder mask on the 2 sides
All the information contained within this document (photos, drawing, features, specifications and dimensions) could be perceptibly different and can be changed without prior notice.
- Mounting in panel with trimming,
persons with reduced mobility.
Fixing plate Security rope Roll pin 5x16
1 2
2,5
M8x25 screw
1 1
Voltage selection jumpers
12V dc
Recommended power supplies
ADC335
V3SR
300 Kg Surface Mount Electromagnetic lock
(For general use - not fire safety use)
INSTALLATION
Security rope
M8 screw
Roll pin
12 round chips 2mm
for the tester pins
3x8 screw 4x25 screw
2 1
Cap nut Manual
1 1
3
24V dc
3,05 18,10
BS60
G0301FR1024V01
5,6
Fixing plate
Cap nut
MOUNTING RECOMMENDATIONS
6
Armature plate
- It is vital to fix the electromagnetic lock and
armature plate solidly on their supports.
- Make sure that the magnet and the armature
meet evenly over their entire mating surfaces.
- The armature plate must be able to pivot slightly
about its center mounting screw to compensate
for any door misalignment.
Security rope
(fixing on the magnetic lock and the frame)
Security ropes
The electromagnetic lock undergoes repeated
shocks and the vibration at the points of fixation
on the frame (frequencies of openings / closures,
attempt of opening wears closed and attempts
of vandalism) which can loosen the fixing bolts/
screws.
To prevent the risk of the electromagnetic block
from falling, install both security ropes supplied,
to guarantee the safety of the users (see plan
above).
EN
Security rope
Armature plate
Steel washer
Rubber washer