Certificate; Certificate Of Compliance; Safety Instructions - Bahco IZO-DM Guide De L'utilisateur

CERTIFICATE

Certificate of Compliance
The Torque Wrenches IZO-DM and IZO-DFM are in accordance
with the requirements of:
ISO 6789, EN 26789
The test method and the equipment used for the calibration
is in conformity with the afore mentioned norm. International
traceability through calibration laboratories acc. to ISO 9000.
Contact your BAHCO sales representative for calibration services.
Calibration events are recorded in the wrench memory which provides
evidence to void factory certification.
Equipment Required: A torque source, accurate to 1 % of reading.
Note: To insure specified accuracy:
1. Apply load to the "V" notch on the handle.
2. On flex-ratchet models, the head must be straight.
3. Check calibration every 5000 cycles or annually.
GUARANTEE
The warranty period is 24 months from the date of purchase or date of
invoice and covers faulty parts, materials and defects from poor
workmanship.
If such a case should happen, please contact your local BAHCO Partner for
assistance together with proof of date of purchase of your tool.
Accessories
Download CD for PC
RS232 Output Cable to PC
Patents: US 4,958,541 and Pending
4
EN 10204
CALIBRATION
IMPORTANT !
Part Number
IZO-DM-DOC
IZO-DM-C
IMPORTANT SAFETY INSTRUCTIONS
WARNING: Risk of flying particles.
Over torquing can cause breakage. An out of calibration torque
wrench can cause part or tool breakage. Broken hand tools, sockets
or accessories can cause injury. Excess force can cause crowfoot or
flare nut wrench slippage.
Read this manual completely before using the
IZO-DM/DFM.
For personal safety and to avoid wrench damage, follow good
professional tool practices.
Periodic recalibration is necessary to maintain accuracy.
Wear safety goggles, user and bystanders.
Be sure all components, including all adaptors, extensions,
drivers and sockets are rated to match or exceed the torque
being applied.
Observe all equipment, system and manufacturer's warnings,
cautions and procedures when using this wrench.
Use the correct size socket for the fastener.
Do not use sockets showing wear or cracks.
Replace fasteners with rounded corners.
To avoid damaging the wrench: Never use the wrench
with the power off. Always turn ON the wrench so the applied
torque is being measured.
Do not press ON/ZERO while torque is applied.
Never use this wrench to break fasteners loose.
Do not use extensions, such as a pipe, on the handle of the
wrench.
Check that the wrench capacity matches or exceeds each
application before proceeding.
Make sure the ratchet direction lever is fully engaged in the
correct position.
Verify the calibration of the wrench if you know or suspect its
capacity has been exceeded.
Do not force the head of flex head drives against stops.
Always pull – do not push – on the wrench handle and adjust
your stance to prevent a possible fall should something give.
WARNING: Electrical Shock Hazard.
Electrical shock can cause injury. Plastic handle is not insulated.
Do not use on live electrical circuits.
GB
5