Operation; Storage; Maintenance Instructions; Cleaning Tool - GREENLINE GRE 6 Mode D'emploi

Operation

1. With dry hands, install a fully charged battery into
the electrical tool. Press the ON/OFF button (Figure 2)
to power on the electrical tool. All three tool status will
blink once. Then, the green light should solidly illumi-
nate indicating the tool is ready to operate (See Figure
5 for Tool Status Lights). The electrical tool will auto-
matically turn OFF if left unused for 600 seconds.
Figure 10 – Tool in operation
2. Refer to the instructions for the head in use for specific
operating instructions. With hands clear of the head
and other moving parts, depress the Run Switch to
advance the tool ram and activate the head. The
advancement of the ram can be stopped at any point
by releasing the Run Switch. This allows final posi-
tioning of the head for cutting, punching or gripping
and positioning of connectors.
Unless otherwise stated in the specific head instruc-
tions, continue to press the Run Switch until the ram
automatically retracts. Automatic ram retraction indi-
cates that the electrical tool has reached the appro-
priate force and the cycle is complete. This is required
to ensure the complete crimping of electrical con-
nections.
If the ram does not fully retract, press the pressure
release button. If the pressure release button is
pressed while crimping an electrical connection, the
crimp is NOT complete and needs to be repeated.
3. When operation is complete, press the ON/OFF but-
ton to turn OFF and remove the battery.

Storage

Remove battery from tool. Store electrical tool and battery
in case. Avoid storing in extreme heat or cold. The elec-
trical tool will not turn ON if the tool or battery temperature
is outside of the specification range. This will be indicated
by a tool status light. (See Figure 5.)
8
Store in a dry, secured area that is out of
WARNING
reach of children and people unfamiliar with the Electric
Tool. The electrical tool is dangerous in the hands of
untrained users.

Maintenance Instructions

WARNING
Remove battery from tool before performing main-
tenance or making any adjustment.

Cleaning Tool

Wipe exterior of the electrical tool clean daily with a clean,
dry cloth.

Cleaning QCS Coupling

Point the QCS opening down and gently shake any debris
out. Visually inspect the QCS opening for any debris.
Cotton swabs can be used to wipe out debris. Do not let
material build up into the retaining ball pockets (Figure 7).
The QCS coupling is lubricated for life at the factory. Do
not add any lubricant to the QCS coupling,
Required Maintenance By Greenlee
Authorized Service Center
The Electrical tool must be serviced at set intervals by an
Authorized Service Center to ensure proper operation.
This will be indicated by a tool status light (See Figure 5).
See Specifications for service interval.

Service And Repair

WARNING
Improper service or repair can make machine
unsafe to operate.
Service and repair on these Electrical Tools must be per-
formed by an Authorized Service Cent er. Use only RIDGID
service parts.
For information on your nearest Authorized Service Center
or any service or repair questions see Contact Information
section in this manual.
999-999-200.10_REV. A