Castlenet Communications Network - Prince Castle DHB-BK Série Mode D'emploi

General
The Prince Castle DHB-BK1PC, DHB-BK3PC Bins, Retro Bun Timer and
New Bun Cabinet Timers can be inter-connected to form the CastleNet®
Communication Network. The network can be used for data transfer
between bins and timers for menu updates or to transfer product hold
time from bin-to-bin.
Each bin is supplied with a standard 25' cable and allows units to be
"daisy-chained" together to form the network. Extender cables are
available (refer to the Parts List on page 12).
The factory default address for all bins and timers is address .
The factory default address for the Retro Bun Timer is u F.
2
To check the bin address,
press and hold the ACTUAL
and SETPOINT buttons. The
display will show the bin
address. Default for a new
address is .
EXAMPLE: If a location has
three bins, the bins and
timers must be set to address
1 through 3. See the
following steps.
Use the UP or DOWN Arrow buttons to scroll to the desired
address. Press the Burger King Logo Button to store the new
4
address.
Available addresses are:
1 thru
9, , , C,
and
F.
IMPORTANT: A timer address must
match the corresponding bin
address. For example, if the bin
address is , the timer address
must also be . Continue to step 5
to check the timer address. Two
timers mounted on different bins
cannot have the same address.
To change the timer address, disconnect power to the unit and
wait 30 seconds. Reconnect power to the unit and immediately
6
press and hold the BURGER KING LOGO button and the DOWN
Arrow button until the display shows
The address number will blink on/off.
TRANSFER
SET ADDR
DHB-BK1 541-520 Rev. D
®
CastleNet Communications Network
bin2
,
bin3
⇑ ⇓
⇑
ENTR BIN 2
Telephone jack plugs are located on the back of the unit.
3
Connect the units using the cables provided as shown here.
White Plug
Jack
(in from
another unit)
To change a bin address, disconnect power to the unit and wait
30 seconds. Reconnect power to the unit and immediately press
3
and hold the ACTUAL and SETPOINT buttons.
Continue to hold the buttons
until PROG LED turns on.
To check the timer address, press and hold the BURGER KING
LOGO button and the DOWN Arrow button. The current timer
5
address will be displayed in the far right timer display.
To change the timer address, proceed to step 6.
TRANSFER
EGGS
Use the UP or DOWN Arrow button to scroll to the desired
address. Press the ENTER button to store the new address and
7
return to normal operating mode.
.
Available addresses are:
1 thru
9,
MEN ENTR
ENT
9
Product Holding Bin
DHB-BK Series
Power Cord Inlet
Blue Plug Jack
(Plug timer data cable
into here)
Black Plug
Jack
(out to
another unit)
bin2
EGGS EGGS EGGS
, and
, , C, F.
MENU
BIN 3
ENTER
Printed in USA 0 5 06 © 2003
MENU
BIN 2
ENTER
BK
RE