Prince Castle DHB-BK Série Mode D'emploi page 5

Press the UP or DOWN Arrow Buttons until the desired shelf
2
LED and upper (U) or lower (L) heater is selected.
Press the UP or DOWN Arrow Buttons until the desired
4
setpoint temperature is displayed
1
Use the following steps to calibrate
the individual heaters.
NOTE: Allow sufficient amount of
time for temperatures to stabilize
before starting calibration.
Press the UP or DOWN Arrow
Buttons until the desired shelf LED
and upper (U) or lower (L) heater is
selected.
Press and hold the BURGER KING
3
LOGO and ACTUAL Buttons for 5
seconds. The semi-colon (:) LED
indicator will light. The temp dis-
played is the actual heater tempera-
ture sensed by the controller.
7  !

DHB-BK1 541-520 Rev.D
Setting Temperature (continued)
U225
U2'20
'
Calibrating Heaters
U225
To clear any offset
readings, press the
SETPOINT Button.
7  !

Press and hold the SETPOINT Button and the Burger King
3
Logo Button for 5 seconds. The Program LED will light.
Press the Burger King Logo Button to save the new setpoint
5
value. Repeat steps 2—5 to change the setpoint for any other
heater..
Take a temperature reading within the shelf near the center of
2
the heater surface.
Use a standalone temperature meter (not supplied).
Hot surfaces. Use caution when taking
temperature readings within the shelf
Press the UP or DOWN Arrow
4
Buttons until the temperature
displayed matches the reading
obtained in Step 2.
U2'20
'
5
Product Holding Bin
DHB-BK Series
U225
U220
WARNING
Press the BURGER KING LOGO
Button to save the temperature
value and exit the Calibration
Mode.
Printed in USA 0506 © 2003