Setting Temperature; Cleaning - Prince Castle DHB-BK Série Mode D'emploi

7
To change a menu selection for a specific pan cavity, use the following steps:
A. Press and hold the Burger King Logo Button for 6 seconds. All Pan
Displays will show "PROG". All LED Timers will be red.
B. Press and hold the DAYPART/ENTER Button. The display next to the
DAYPART/ENTER Button will display the menu choices. While holding
the DAYPART/ENTER button, press the UP or DOWN Buttons to scroll
through the menu choices.
C. Press a PAN Button to change the menu. The LED Timer will change to
yellow and the Display will change from "PROG" to the assigned menu
item.
To shut down the unit, turn the power On/Off switch to OFF.
8
The unit has two shelves, each with an upper and lower heater (four heaters total).
The factory pre-set for the two upper heaters is 225°F.
1
The factory pre-set for the two lower heaters is 195°F.
Each heater has a programmable range of 150° - 250°F.
Use the control below and the following steps to set the setpoint temperatures for each heater.
UPPER SHELF LED
This LED will be lit to indicate
upper shelf is selected
PROG LED
This LED will be lit to indicate
unit is in Program Mode
LOWER SHELF & LED
This LED will be lit to indicate
lower shelf is selected
ACTUAL TEMP BUTTON & LED
Press to display actual temperature for the
selected heater. LED will be lit when actual tem-
perature is displayed.
SETPOINT BUTTON & LED
Press to display setpoint temperature of a
selected heater. LED will be lit when setpoint
temperature is displayed.
NOTE: To reset all times and temperatures to the factory settings, turn the unit off, then press and hold the UP and DOWN arrow buttons
simultaneously while turning the unit back on. A "P" will appear in the display and all times and temperatures will be reset to original factory settings.
DHB-BK1 541-520 Rev. D
Operation (continued)
D. Press the UP or DOWN Button to
scroll to the desired menu item.
F. Repeat steps A - E as required for other Pan Displays. Press
the Burger King Logo Button to exit the program mode.
NOTE: Up to six menu items may be programmed for each Pan
Button. In addition, a pan may be set as "not used" by assigning
"----" as its product.
Before performing any maintenance, turn the power switch to the OFF
position and unplug the power cord from the electrical receptacle.
This unit is not watertight. Do not clean with a water jet/jet spray.
1. Turn the unit off and unplug the power cord from the electrical
2. Remove the pan covers and pan racks. Wipe all parts and unit

Setting Temperature

U225
4
Product Holding Bin
E. Press the DAYPART/ENTER

Cleaning

WARNING
CAUTION
Do not immerse the unit in water.
receptacle.
with a damp cloth. DO NOT use a green scotch bright pad cleaner,
ice or water.
TEMPERATURE DISPLAY
U=Upper Heater
L=Lower Heater
NOTE: The unit is preset to display temperature in
Fahrenheit. To display in Celsius, press and hold
the DOWN Arrow button immediately after turning
on the power switch. To switch back to Fahrenheit,
press and hold the UP Arrow button after turning
on the power switch.
UP/DOWN ARROW BUTTONS
Used with other buttons to scroll
through heater and temperature
BURGER KING LOGO BUTTON
Press to enter
temperature selections
Printed in USA 0506 © 2003
DHB-BK Series
button to select the menu item.
selections