SCHOTT VisiLED Serie Conseils D'utilisation page 66

Parameter setting for MC 1500
Precise setting of the parameters only
by computer control of the MC 1500.
The MC 1500 controller's keypad only
allows rough visible adjustment.
* The values indicated with * can
only be changed via computer .
The values indicated with
derivative values that cannot be
directly set.
64 | VisiLED-Serie
Properties
Light
intensity setting
MC 1500
brightness ranges:
1 = No LED lit up
2 = One green LED 2 – 32
3 = Two green LEDs 33 – 59
4 = Two green and 60 – 82
one yellow LED
5 = Two green, one 83 – 100
yellow and one
red LED
Rotation mode
Angle of single
rotation step
illumination time
of each step *
Rotation speed*
Strobe mode
Strobe cycle
duration
Strobe frequency
Strobe pulse
duration
Strobe
intensity*
Trigger mode
Light pulse
duration
Light pulse
intensity*
Delay time*
are Flash mode
Flash
duration
Values
% 0 – 100
0 – 1
45°
2 – 500
0.25 – 62.5 rps
μs 100 – 65000,
(full intensity from on 500 μs)
strobe frequency 15 – 2000 Hz
(10000 Hz)
μs 80 – 65000
% 0 – 100 without overdrive
0 – 300, if overdrive conditions fulfilled
(see Section 8.6)
μs 80 – 65000
0 – 100 without overdrive
0 – 300, if "pulse duration < 10000 μs"
ms 0 – 16000 (only limited settings
possible via controller keypad)
μs 80 – 65000
Tested in
accordance
with
Base setting
32 %
125 ms
1 rps
Deactivated
40000
20 Hz
2500
300
Deactivated
2500
300
1000
2500