OPERATING INSTRUCTIONS
IMPORTANT: Proper filter and bottom filter cover installation is necessary for the unit to turn
on and run.
BEFORE OPERATING THE AIR PURIFIER
1. Select a firm, level and flat location for the air purifier.
• For proper air flow, locate the unit at least 1 foot from any wall or furniture.
• Make sure none of the grills are blocked.
OPERATING THE AIR PURIFIER
1. Turn the air purifier ON by rotating POWER KNOB clockwise to line up with the arrow.
2. Upon turning the air purifier ON, the power indicator will be lit (green) and the unit will be in
LOW mode (I).
3. Rotate the POWER KNOB clockwise to set the air purifier to MEDIUM (II) or High mode (III).
4. To activate the UV-C Bulb, press the UV button. Press the button again to turn OFF the UV-C.
The light on the front of the unit will turn on when the UV-C is on.
5. To turn the unit OFF, rotate the POWER KNOB counter-clockwise to OFF mode (•).
Filter reset
• The power indicator will flash when it's time to change the filter.
• Replace the filter according to instructions (page 7).
• Press and hold the UV button for 5 seconds to reset the filter light.
E-6
UV
FILTER REPLACEMENT
Power light will flash when it is time to replace your filter. Depending on usage and environmental
conditions the filter will last approximately 6 months. The inside pleats of the filter will turn from
white to grey when it is dirty and needs replacing. It is important to maintain and change the filter
to continue to optimize the performance of the air purifier.
IMPORTANT: Do NOT wash and re-use the filter. Please contact Customer Service to purchase
a replacement filter or visit www.guardiantechnologies.com.
REMOVE AND REPLACE FILTER
1. Turn off and unplug the unit
2. Flip the unit upside down
to access the filter cover.
3. Using the grip, turn the lid
4. Lift bottom plate (filter
cover) off of unit.
LEFT to unlock and open.
6. Replace new filter.
7. Replace the lid, align the arrow ( ) with the unlock (
symbol on the purifier, turn RIGHT to close ( ).
8. Reset the filter indicator by holding
UV
the UV-C button for 5 seconds.
IMPORTANT: If the filter is not placed in properly or
the filter cover is not secure, the unit will not turn on.
5. Remove and dispose of filter.
)
E-7