Filter Replacement - Guardian Technologies CDAP4500 Utilisation Et Instructions D'entretien

FILTER REPLACEMENT

The Replace Filter light will flash continuously indicating that it is time to replace
your filter. Replace the filter according to directions then restart the system.
Depending on usage, filter will last approximately 6 months.
1. Turn off and unplug the unit.
2. Press the lock and 3. Remove the used
release button and Combination Filter
remove the rear (Filter B) and dispose of
cover from the unit. it in the garbage.
5. To reset the filter indicator press and hold the timer button for 5 seconds.
CHECKING AND MAINTAINING FILTER
Maintain the filter by checking it frequently.
Depending on air quality conditions, you may need to replace it more frequently.
Vacuum the carbon filter layer as needed to remove loose debris and dust and to help prolong
the life of your filter. (Refer to pg. E5 for filter layers view).
To check the status of the filter, peel back the carbon layer to expose the pleated Filter. If the
Filter is no longer white and is covered in grey dust/dirt it should be replaced.
IMPORTANT: Do NOT try to wash and re-use the Combination Filter.
IMPORTANT: To maintain warranty and the performance of the air cleaner, use Guardian
Technologies GENUINE Replacement Parts only.
Genuine Filter Replacements can be purchased directly at www.guardiantechnologies.com
FILTER (FLT4825)
B
E-8
4. Insert filter system into the unit.
Consult the arrow on the filter
for correct installation direction.
INSTALLING & REMOVING UV-C BULB
UV Bulb Replacement Indicator: The UV light on the display will flash when its time
to replace the UV bulb.
1. Turn off and unplug unit. 2. Remove the
Press the lock and release combination filter.
button and remove the
rear cover from the unit.
4. The UV-C Bulb is removed by carefully grasping the bulb with a clean cloth or tissue and pulling
the bulb straight out of the unit.
Bulb is NOT visible
until the UV-C METAL
SHIELD has been
removed.
5. The UV-C Bulb is reinstalled by sliding it, horizontally, back into the slots at the top of the unit.
6. To reset the UV-C Replacement Indicator, press and hold the UV button for 5 seconds
3. Use a Philips head
screwdriver to remove
2 screws and detach the
UV-C Metal Shield.
Replacement bulb: LB4000
available at 866.603.5900 or
www.guardiantechnologies.com
E-9