Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Parts, Tools, Materials
You will need the following tools and materials for the installation:
Carton or other heavy material for covering the counter top.
Clear Tape
(for taping the templates to the wall)
(for cutting vent holes for roof
or wall vending)
Phillips Screwdriver
(for the screws)
Flat Blade Screwdriver
(for the toggle bolts)
Measuring Tape
(metal preferred)
Small Side Cutters or Tin Snips
●
If you have brick or masonry walls, you will need special hardware and tools.
The ductwork you need for the installation is not included. All wall and roof caps must have a back-draft damper.
●
(Shown on page 6).
Saber Saw
Pencil
Stud Finder or Thin Nail
Keyhole Saw (for the power cord hole)
3/8" and 3/4" wood drill bits
1/2" and 3/16"
drill bits
7
Electric Drill
Plumb Line
Duct Tape
Caulking Gun
Publicité
Chapitres
Table des Matières
