Storch 620020 Mode D'emploi page 86

Fitting accessories (Figs. 8, 9, 10, 11) (cont.)
WARNING:
Never fit the circular saw or straight cutting tool facing backward (Fig. 8); working with the tools in this position can
cause severe injuries.
Remove the battery pack from the Multi-Tool.
Loosen the flange bolt with the Allen key provided. (Fig.9)
Ensure that the inner threads and the drive shaft are clean.
Align the grooves on the tool with the four raised ribs on the drive shaft; push the tool onto the shaft. (Fig. 10)
With your gloved hand holding the blade, put on and tighten the flange bolt using the hex key.
NOTE:
Depending on the application, move the tool into the correct position. The drive shaft is designed so that the tools can
be fitted at 30° angles around the shaft (Fig. 11).
Original instruction 86