Connecting The Breastmilk Expression Set; Connecting For Single Pumping; Using The Lansinoh Smartpump; Power Options - Lansinoh SMARTPUMP Mode D'emploi

4.2 Connecting the Breastmilk Expression Set

Once Breastmilk Expression Set is assembled, connect to pump base:
1. Secure one end of 600 mm
tubing to Tubing Y Connector.

4.3 Connecting for Single Pumping

1. Remove one of the 300 mm
tubing from the Tubing Y Connector.
12
Smartpump_Manual_CA_082317.indd 12-13
2. Secure other end of 600 mm tubing
firmly to the pump connector.
3. Insert pump connector into opening
on left side of pump.
2. Secure plug into open outlet of
Tubing Y Connector.
5. USING THE LANSINOH SMARTPUMP DOUBLE ELEC-
TRIC BREAST PUMP

5.1 Power Options

The pump may be operated using the following power supply modes:
AC Adapter
1. Connect the AC adapter to the power
receptacle located on the right side of
the pump. Plug the AC adapter into an
available electrical outlet.
2. Electrical safety can only be achieved
when the breast pump is connected to
the AC Power adapter supplied with the
product. (See "Technical Data" section,
page 21)
AA Alkaline Batteries (not included)
1. Make sure the batteries are inserted correctly
according to the polarity (+) and (-) as indicated.
2. Close the compartment by gently pressing
the cover until it snaps into place.
Remove batteries if pump is not in use for a long period of time.
●
Dispose of batteries according to regulations for environmental
●
protection and recycling.
Replace batteries as a simultaneous set. Do not mix old and
●
new batteries.
Do not mix alkaline and standard (carbon-zinc) batteries.
●
If batteries are in the pump, but AC adapter is in use, the pump will
●
use the adapter to power the pump, not the batteries.
For the most economical use, we recommend using your pump with the AC adapter
provided. Your AC adapter is a universal AC plug adapter type and can be used with
100 Vac to 240 Vac systems with 50Hz and 60Hz mains.
13
8/28/17 11:49 AM