Instructions For Correct Use, Safety Instructions - Gloria Gardenboy PLUS 400 W Mode D'emploi

Fault
The appliance is switched on but
the spike-tooth discs come to
GB
a halt when making soil contact.
The appliance blocks
when in use.
The tines of the spike-tooth discs
are loose, bent, worn.

11. Instructions for correct use, safety instructions

Check each time you use
the equipment
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and/or if the cutting device is
damaged or worn. Never dis-
able safety devices.
Always carry out a visual
inspection before use in order to
determine whether the working
tool is worn or damaged or
whether screws are loose.
Inspect the surfaces to be
worked before commencing
work. Remove any foreign bod-
ies (e.g. stones, branches or
bones). Watch out for foreign
bodies during work.
Always wear sturdy footwear
and long trousers when working
with the appliance. Do not use
it when barefooted or only wear-
ing light sandals.
The working tools are to be
regularly inspected for signs of
damage and if necessary,
professionally repaired.
Only have working tools
replaced by GLORIA-Service or
the authorised stockists.
22
Remedy
Inspect the screwed connections and the retainer of the spike-tooth
disc. Please contact your stockist or GLORIA-Service direct if this does
not solve the problem.
A blocking of the motor results in the clutch slipping.
The appliance can be immediately restarted after the cause of
the blocking has been removed. If the clutch slips too often, you
should alter you working method as the mechanical components
could otherwise be damaged.
The spike-tooth discs can wear. For a safe use of the appliance
and a good working result, it is important that they be replaced
when they are worn. For the replacement of the spike-tooth discs
please contact your stockist or GLORIA-Service direct.
Use/
Responsibility
Caution! The safety devices
installed on the appliance
by the manufacturer are neither
to be removed nor bypassed as
this can result in injury.
Make sure that there are no
other people (especially children)
or animals within or near the
working area.
Powered equipment can cause
serious injuries! You are respon-
sible for safety in the area where
you are working. Never start the
equipment whilst tilted – risk of
injury!
Always use the equipment solely
for the purpose described in the
operating instructions.
Only use this unit in daylight or
when the area where you are
working is lit by ample artificial
lighting.
Make sure that the air vents are
free of dirt.
Ensure that you are standing
safely and on firm ground, even
on a slope.
If the mains cable should
become caught in the working
tool, switch the appliance off
and remove the plug.
Be careful if you are going back-
wards, risk of stumbling!
Work at an angle to the slope,
never upwards and downwards.
Do not work on excessively
steep slopes.
Only use the appliance at
a walking pace. Take special
care when turning the appliance
around or pulling it closer to you.
Turn the motor off if the equip-
ment has to be tilted when trans-
porting it over surfaces other
than grass and if you are trans-
porting the equipment back-
wards and forwards to the work
area.
Never use the appliance if the
protective devices are not
mounted or if they are damaged.
Start or activate the start button
with care, in accordance with the
manufacturer's instructions.
Ensure that there is sufficient
clearance between the feet and
the tool.