Remington 493 Mode D'emploi page 9

30
2. Should the tool fail to fire, hold the muzzle firmly against the work surface for 30
seconds. Release the trigger and remove pressure on the tool while holding the
muzzle against the work surface. Again press the tool firmly against the work
surface and pull the trigger. If the tool still fails to fire, hold the tool firmly against
the work surface for another 30 seconds before advancing the power load strip.
Use remaining loads in strip. Discard power load strip into water or oil.
3. ALWAYS use the spall shield when driving directly into concrete or steel.
ALWAYS wear eye protection.
482-49
4. NEVER use a powder actuated tool in an explosive or flammable atmosphere or
when non-sparking tools are required.
POWER LOADS AND POWER FASTENERS
1. NEVER leave unfired power load strips on floors or work surfaces.
114915
Safety Precautions
WATER
Spall
Sheild
GAS
GASOLINE
OLINE
482-50
9