Operating The Tool - Remington 493 Mode D'emploi

Safety Precautions
3"
482-38
6. DO NOT drive power fasteners into concrete less than three times as thick as the
intended fastener penetration, within 3" of the edge, within 3" of another power
fastener, or within 3" of a failed power fastener.
WELD
482-40
TOO THIN
7. DO NOT drive power fasteners into steel base material less then 3/16" thick,
within 2" of a weld, within 1/2" of the edge, or within 1" of another power fastener.
NO
8. When fastening into masonry walls, always drive into horizontal mortar joints,
NEVER into vertical mortar joints. BE CAREFUL, A poorly laid joint may permit
too much penetration, and/or unsatisfactory holding power.

OPERATING THE TOOL

90˚
1. ALWAYS hold tool perpendicular to work surface.
1X
3X
3/16" MIN
3"
3"
3"
482-39
1"
1/2"
482-41
YES
8
114915