Remington 493 Mode D'emploi page 19

6. Remove piston assembly from piston sleeve (see Figure 4).
Figure 4 - Removing Piston From Piston Sleeve
7. Tilt rear of base plate down. Guide will slide out.
B. REMOVING RUBBER PAD
1. Loosen screw on back of rubber pad with 5mm Allen wrench.
2. Detach rubber pad from top of tool first, then pull entire rubber pad from tool.
C. REMOVING ROCKER ARM
Rocker arm assembly is located on rubber pad.
1. Push out rocker arm pin (see Figure 6).
2. Remove rocker arm and spring from rubber pad.
Rocker Arm
114915
Tool Disassembly and
Figure 5 - Removing Rubber Pad
Spring
Figure 6 - Removing Rocker Arm
Assembly
Rocker Arm Pin
19
Piston Sleeve
Rubber Pad
5mm Allen Wrench
Rubber Pad
Piston