Hydraulic Connections - Hoover H-WASH 700 Mode D'emploi

Hydraulic connections

l
Connect the water hose to the water
supply tap (fig. 3) only using the hose
supplied with the appliance (do
reuse old hose-sets).
l
SOME MODELS may include one or
more of the following features:
l
HOT&COLD (fig. 4):
water mains connection settings with hot
and cold water for higher energy savings.
Connect the grey tube to the cold water
tap and the red one to the hot water
tap. The machine can be connected to
the cold water tap only: in this case, some
programs may start a few minutes later.
l
AQUASTOP (fig. 5):
a device located on the supply tube that
stops water flow if the tube deteriorates;
in this case, a red mark will appear in the
window "A" and the tube must be
replaced. To unscrew the nut, press the
one-way lock device "B".
l
AQUAPROTECT – SUPPLY TUBE WITH
GUARD (fig. 6):
Should water leak from the primary
internal tube "A",
containment sheath "B" will contain water
to permit the washing cycle to complete.
At the end of the cycle, contact the
Customer Service Centre to replace the
supply tube.
not
the transparent
67
3
4
1
5
A
6
A
B
B