Instructions For Use; Inserting/Replacing The Battery; Battery State Of Charge; Switching On And Off - Flex CL 2000 18.0 Notice D'instruction D'origine

CL 2000 18.0

Instructions for use

WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power tool
Unpack power tool and accessories and
check that no parts are missing or damaged.

Inserting/replacing the battery

 Press charged battery fully into
the power tool.
 To remove the battery, press the release
buttons (1.) and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; there is a risk
of explosion and fire!

Battery state of charge

 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.

Switching on and off

 Switch the rechargeable LED work light
on and off by pressing the on/off switch.
Press again to adjust the light intensity.
11