Cleaning The Ceiling Cover; Cleaning The Air Filter; Installation Instructions For Stacking - Buffalo GK640-E Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 66

CLEANING THE CEILING COVER

1. Hold side stoppers of ceiling cover with both hands and pull them in and down.
Then take the ceiling cover out of the oven cavity.
2. Rinse ceiling cover in soapy water or Food Sanitizer Solution.
3. Be sure to replace the ceiling cover before using the oven.
Ceiling cover must be in place securely when you use the oven. When you
removed the Ceiling Cover for the purpose of cleaning, be sure to be extremely
CAUTION
careful about the exposed inside components on the top of the oven cavity. If
any of them are deformed, abnormal symptom can happen such as arcing or
sparks during operation. In case of such problem, contact the nearest after-sales
service centre.
Ceiling Cover
CLEANING THE AIR FILTER
Clean the Air Filter regularly according to the following instructions.
The oven may have problems when the Air Filter becomes clogged with dust.
1. Remove the bolt at both ends of the Air Filter.
2. Lift the Air Filter off the post carefully.
3. Wash this filter in warm soapy water.
Bolt
4. Be sure to replace the Air Filter before using the oven.
If the Air Filter becomes clogged with debris, this will cause an overheating problem
on the oven.
If the want to change the air filter clean time, refer to "Programming Air Filter Clean
Time" in page 20.
GK640-E_GK641-E_XEU_DE68-04279B-01_EN.indd 22

INSTALLATION INSTRUCTIONS FOR STACKING

Important
1. Disconnect the power cord from the wall socket before attempting installation.
2. For stacking installation, you must use the "bracket plate" which is enclosed with
this unit.
3. The maximum stacking height is two units.
Stacking the two units is limited to the following models.
Be sure the oven cavity is empty.
CAUTION
Installation
1. Stack two units together.
2. Remove 6 screws as shown in the figure.
3. Place the Bracket-plate to join the two units.
4. Attach and tighten 6 screws as shown in the figure here.
5. Ensure the top oven is at a safe and workable height.
Bracket-Plate
English - 22
Screw
2014-06-27
6:49:55

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gk641-e

Table des Matières