Samsung WF361 Manuel D'utilisation page 18

setting up your washer
4. Turn on the HOT and COLD water supply and check all
connections at the water valve and the faucet for leaks.
5. Slide your washer into position.
6. Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with your
washer.
When your washer is level, tighten the locking nuts using the
wrench or (-) flathead screwdriver.
7. Plug the power cord into a 3-prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third prong of the power
cord when plugged into a three-prong grounded receptacle.
Your washer must be leveled on all four sides. Use a
carpenter's level on all four corners of your washer to ensure
it's level. It's also a good idea to recheck the leveling after
the first dozen washes.
Avoid damage to the legs. Do not
move the washer unless the locking-
nuts are fastened to the bottom of the
washer.
18_ setting up your washer
WF361_363_365-02832J-03_EN_20120829.indd Sec5:18 WF361_363_365-02832J-03_EN_20120829.indd Sec5:18
Cold printed Hot printed
2012-08-31 2012-08-31 12:38:17 12:38:17