Theben LU 102/180 H Manuel D'utilisation page 18

Manuale_LU102_180HF
Please follow the steps below to change the channel setting of Transmitter
LU 102/180 HF.
1. Turn sensor head until the rubber cap can be seen where channel swit-
ches are located inside.
2. Draw the rubber cap with a clamp to get the channel knob (See Fig. 1) .
• The rubber cap is used to provide waterproof function, can pull
only, can not take it off the case.
Fig. 1
18
3. Rotate the coding dials gently with a screwdriver, adjust them to your
desires positions (See Fig. 2) .
4. Put the rubber cap back.
Fig. 2
Note: System channel (or house channel) and unit channel have each 16
sets coding that provide flexible combination capability a total of 256
(16x16) different combinations.
2004.3.30 12:39 AM
System Channel Unit channel
(house channel)
Page 18