ShelterLogic UltraMax 30x50 Instructions D'assemblage page 6

step 5
Depending on the model you have purchased, your
base feet will either fit onto the outside of the leg poles,
or slide inside the leg poles.
After installing Base Feet Plates onto bottom of Leg
Poles, line up the predrilled hole in the leg with the
predrilled hole in the base foot. Insert
the way through leg and foot to other side, secure with
nuts.
Note: Don't insert the bolt to the corner legs at this
step.
Place 4 anchors as shown in Fig. 5B into each hole of
the base feet until the head of the anchor touches the
base feet.
step 6
Tie a loop into the end of the
rope.
Feed the loop over the
top of the rafter pole and feed
the other end of the rope through
the loop and run the rope down
the leg at least 12 inches and wrap
the rope around the leg and
feed the loose end over the
rope (Fig.6A).
Take the loose end of the robe
and secure it to the auger
anchor already secured in the ground
(Fig.6B).Repeat these steps for the
remaining legs on the canopy.
/
5 x 3 in.
11130 16 clamps
Fig.7A
800221
690
middle
clamps
11130
800220
Fig.7B
690
corner
Fig. 6
Fig. 5A
bolts all
Page 6
Fig. 5B
Fig. 6A
rope
Fig. 6B
05-27774-0B