ClearSounds CSC1000 Mode D'emploi page 16

Setup
3. Run
and push excess cord behind the plate.
4. Attach
a. Line up the keyholes on back of the phone
with the raised mounting pins on
b. Pull
c. Slide
5. Connect
6. Slide
To simply hang the phone on the wall
This method requires two self-tapping screws (included).
1. Locate a wall location within six feet of a telephone jack
wall plate and within nine feet of an AC power outlet.
2. Install the screws on the wall in a vertical line, at
a distance of 3.15 inches from each other.
3. Line up the keyholes on back of the phone over
the screws, and slide the phone downward until
it is securely seated.
4.
Connect
phone base, and then connect it to
14
through the opening on
to the phone:
toward the phone.
upward until it is securely seated.
to
over the phone jack wall plate.
to
on the wall.
on the back of the
in the wall.
,
.