Adjusting The Shock Setting; Setting The Parking Brake; Securing The Child In The Seat - B.O.B REVOLUTION FLEX 3.0 DUALLIE Guide De L'utilisateur

BOB Gear
6� Test Alignment
Push stroller straight forward and
release to see if stroller veers right
or left. Repeat push test several
times.
If stroller consistently pulls to
left or right, see Fine Tuning the
Tracking.
Fine Tuning the Tracking
If Stroller Pulls LEFT
If your stroller pulls LEFT, turn
tracking knob counterclockwise up
to one half turn.
Tracking Knob
If Stroller Pulls RIGHT
If your stroller pulls RIGHT, turn
tracking knob clockwise up to one
half turn.
REPEAT roll test and adjust as
needed until stroller rolls straight.
Tracking Knob
10
Do not roll test with a child or
any occupant in the stroller�

Adjusting the Shock Setting

1� Remove Child From Seat
2� Set Shock Setting
Depress shock release knob
and simultaneously pull toward
back of stroller, sliding knob
into preferred position. Knob will
snap into place when in correct
position.
Position 1 is a SOFTER shock
setting recommended for
children 50 pounds (22�7 kg) or
less�
Position 2 is a FIRMER shock
setting recommended for
children weighing 51 to 100 lbs
(22�8 - 45�4 kg)
NOTE: Every time stroller is
folded, stroller shocks default to
position 1.
3� REPEAT on opposite side�

Setting the Parking Brake

The parking brake prevents the
stroller from moving while loading
and unloading. The parking brake is
not designed as a stopping brake.
To set the parking brake, press down
on the foot pedal – making sure the
locking pin fully engages the locking
disk.
LOCKED POSITION
To ensure the brake is set properly,
attempt to roll the stroller forward
and backward after setting the
brake. If the stroller will not roll, the
brake is set properly.
To release the parking brake, lift up
on the foot pedal with your foot until
the brake bar springs up into the fully
unlocked position.
UNLOCKED POSITION
Do not park on inclines� The
parking brake is intended
to park the stroller on flat
surfaces only� Parking on
inclines may result in tip over
or runaway stroller�
REVOLUTION FLEX 3.0 DUALLIE User Guide

Securing the Child in the Seat

Before each use, check the harness
and its components to make sure
they are in good condition and good
working order.
1� Set Parking Brake
Rotate parking brake down into
locked position.
NOTE: Rear wheels should not
rotate when parking brake is set.
2� Place Child In Seat
Slip one shoulder strap over each
shoulder. Position buckle strap
between legs.
Shoulder Strap
Buckle Strap
3� Fasten Shoulder Straps
Insert both shoulder strap
tongues into the buckle.
NOTE: Buckle strap should be
adjusted to have a snug fit.
Buckle
4� Adjust Shoulder Strap Height
Adjust height of shoulder strap
to fit just above child shoulder
height.
11