Before Using Your Ice Maker For The First Time; Control Panel Operation - Sonnenkonig EASY Mode D'emploi

4 Before using your ice maker for the first time

•
During transportation, the unit should not be tilted more than 45°.Do not turn the ice
maker upside down. As this may damage the compressor and sealed system.
GB
•
Remove all packaging materials and carefully check your ice maker to ensure it is in
good condition and that there is no damage to the ice maker power cord or plug.
•
The ice maker should be placed horizontally on a level surface.To ensure proper venti-
lation for your ice maker, allow 150 mm of space at the top, the back and on each side.
Do not install the ice maker near a cooker, radiator, or any other source heat.
•
Please wait 2 hours after positioning the ice maker before using the ice maker for the
first time. Keep the front lid open for at least 2 hours.
•
Ensure that the voltage indicated on the ice maker corresponds to the voltage in your
home.
•
Spring water recommended.
•
Make sure the silicon stopper is correctly inserted.

5 Control panel operation

ON/OFF: Press this button to turn the unit on or off.
ADD WATER: If this light illuminates and a long beep sounds, you must add water. Press
the ON/OFF button to stop the appliance. Add water, then press the ON/OFF button to
restart the ice maker.
ICE FULL: If this light illuminates and a double beep sounds, this indicates that the ice
basket is full. Remove sufficient ice cubes from the ice basket and press the ON/OFF
button to restart the ice maker. Please bear the maximum permitted quantity in mind and
do not overfill the basket.
44