Cleaning And Maintaining Your Dishwasher; Cleaning The Exterior; Cleaning The Interior; Cleaning The Nozzles - Samsung DMT610 Série Mode D'emploi

cleaning and maintaining your
dishwasher
Keeping your dishwasher clean improves its performance, reduces unnecessary
repairs, and lengthens its life.

CLEANING THE EXTERIOR

It's best to clean spills on the outside of your dishwasher as they occur. Use a soft, damp cloth on the
control panel to gently wipe away spills and dust. Do not use benzene, wax, thinner, chlorine bleach, or
alcohol. These materials may discolor the dishwasher and cause stains. Do not clean the dishwasher by
sprinkling water over it and avoid letting water come into contact with any of the electrical parts.
If your dishwasher has a stainless steel door panel, you can clean it with a stainless steel cleaner for
Home Appliances or similar product using a clean, soft cloth.

CLEANING THE INTERIOR

Clean the interior of your dishwasher periodically to remove any dirt or food particles. Wipe the inside of
the dishwasher and the inner part of the door with a wet dishcloth. We recommend fi lling the detergent
dispenser with dish detergent, and then running the dishwasher empty periodically using either the Normal
or Quick cycle with the sanitize option. This will keep your dishwasher clean.
If white spots and odor are present in your dishwasher, run the Normal cycle with the dishwasher empty
and without detergent until it fl ushes. Then, interrupt the cycle and put an 8 ounce cup of white vinegar into
the lower basket. Close the dishwasher and let the cycle fi nish.
Do not remove the Seal tub front (the long rubber seal enclosing the opening of the dishwasher).
CAUTION

CLEANING THE NOZZLES

If your dishwasher does not seem to be cleaning adequately or the nozzles seem clogged, you can clean
each of the nozzles. When removing the nozzles, take care as they may break.
Lower nozzle
1. Check whether the nozzle holes are
clogged by food particles.
2. If cleaning is needed, remove the nozzle by
pulling it upwards.
3. Clean the nozzle holes, and then push the
nozzle back into place.
4. Check whether the nozzle is engaged
correctly by rotating it by hand.
20_ cleaning and maintaining
DMT610_DD68-00085A-02_EN_20120921.indd Sec5:20 DMT610_DD68-00085A-02_EN_20120921.indd Sec5:20 2012-09-21 2012-09-21 2:04:16 2:04:16