Broan EC60KIT Mode D'emploi page 2

INSTALLATION
1. Disconnect the electrical power supply
and lock out the service panel for the
existing fan.
2. Remove grille from the existing fan.
GRILLE
Pull grille down to expose two springs. Squeeze each spring
together and pull down again to release springs from motor
plate slots.
3. Remove blower
existing fan.
SCREW
(SET ASIDE)
SIDE OF
HOUSING
Unplug motor cord from receptacle and remove screw located
next to receptacle. If necessary, insert a straight-blade
screwdriver between motor plate and side of housing near
the screw location and gently pry housing away from motor
plate.
SPRING
assembly from the
MOTOR PLATE
3. Remove blower
existing fan (cont'd).
Pivot blower assembly down and out.
4. Check existing housing.
Vacuum the interior of the existing fan housing with a dusting
brush attachment. Examine the housing to make sure it is
securely fastened to the building structure and free of any
holes caused by corrosion. The receptacle must be intact.
If any damage is found, do not continue installation of this
product. Contact a qualified person(s) for repair..
MODEL EC60KIT
Page 2
assembly from the