Start-Up; Remote Control - Kenwood CR-ST100S Mode D'emploi

2. Start-up

2.1 Unpacking
Carefully unpack the device and make sure all accessories are present:
• Infrared remote control
• Mains adapter
• Operating instructions
• 2 x AAA/LR03 batteries
• Audio cable 1.5 meters - 3.5mm jack plug
2.2 Connecting
• Connect the mains adapter to the radio and to the mains socket.
• Open the battery compartment of the remote control and insert the batteries with correct
polarity.
The specified polarity (+/-) is marked in the battery compartment.
2.3 DAB + / FM telescopic antenna
1. Carefully unlock the antenna on the left side of the casing.
2. Turn the antenna upwards and pull out all the elements completely.
3. Align the antenna for the best reception.
2.4 Network connection
In order to receive Internet radio, the radio must be integrated into a network. To do this, the router
must be switched on and connected to the Internet. Make sure that the WLAN connection of the router
is activated. You can also consult the router's operating instructions.

2.5 Remote control

6
Standby On/Off; Alarm clock off
Set snooze
Mode selection open/close
Menu open/close
Set alarm clock
Music: Random/repeat selection
Play / Pause
Select track
Bluetooth pairing; Disconnect
High; FM: Set frequency
Down; FM: Set frequency
Left; step back
Right; Next Step
Confirm input; FM: Search;
Radio image, slide show in full screen mode
Select equalizer preset
Mute, Unmute
Softer / louder