Assembly Steps - habitat et jardin USAIN Mode D'emploi

these yourself.
17. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
18. Put your feet on the side rail before using the treadmill, and always attach the safety pull pin rope to
your clothing. Hold the handle bar before the running belt moving well (feel the running speed by your
single foot before using it). To avoid loss balance, please slow down the speed to the lowest or take off
the safety. And hold the handle bar to jump to the side rail when emergency or the safety key is not
attached.
19. Make sure the treadmill has stopped before folding. Please don't operate it after folding the treadmill.
ASSEMBLY STEP ONE：
Open the package, take out all parts and place the main frame on the flat ground. (NOTE: please don't cut
Open the package,take out all parts and place the main frame on the flat ground.
down the packing straps.)
ASSEMBLY STEP TWO:
2. Cut off the packing straps. then connect the Extension under wire (74) with extension wire(73)
together.
3. Lock the upright tube(2,3) on the bottom frame(4) with the screw(55) and washer(32).(NOTE: please
don't lock them tightly.).At last, cover the protective guard(56L/R)

ASSEMBLY STEPS

25
onto the upright tube(2,3),