Transport - SPIT 1630P Notice D'utilisation

CLEANINg
NOTE: Acids, alkalis and solvents can corrode the vacuum cleaner parts.
Clean the container and accessories with water.
Wipe the top section with a damp cloth.
Allow the container and accessories to dry
rEpAIr
DANgEr: Inappropriately repaired vacuum cleaners present a danger to the operator.
Have repairs carried out by specialists, e. g. customer service. use only genuine spare parts.

TrANsporT

Insert the closing plug of the vacuum cleaner into the suction aperture.
The motor head must be securely fixed to the container (close the latches).
Place the accessories in a suitable plastic bag and seal the plastic bag or place it in the tool storage
compartment.
Plug the ends of the suction hose into each other.
Place the hose around the vacuum cleaner and clamp onto the handle.
fIrsT AID IN THE EvENT of A fAuLT
fault
Reduction in suction
Vacuum cleaner will not start
The vacuum cleaner does not
start when the tool is switched on
in the >AC< mode
PE emptying and disposal bag is
sucked against the filter
Vacuum cleaner classes M or H: with
inserted paper filter dust in filter
Do not take any other action and contact the central customer service workshop.
14
possible cause
Filter contaminated
Paper filter full
Container full
Nozzle, pipes or hose blocked
Mains plug plugged in?
Mains power missing?
Mains cable OK?
Cover closed properly?
Water sensor switched off?
Vacuum cleaner in readiness for
operation >AC<?
Is the mains plug of the unit in the
plug socket?
Solenoid valve of compressed air
automatic switch-on contaminated?
Position of rotary slider incorrect
Position of rotary slider incorrect
remedy
Clean.
Change.
Empty.
Clean.
Set to >I< or >A< .
Put the mains plug in the vacuum
cleaner plug socket
Flush the compressed air automatic
switch-on with alcohol
Set rotary slider to 4 l position.
Set rotary slider to 4 ▲ position.