Connecting To A Power Source - Toro Ultra 350 Manuel De L'utilisateur

4. Install the inlet cover.
5. Lock the inlet cover in place.
Important: The blower will not run unless the bottom
inlet cover is locked in place.
Operation

Connecting to a Power Source

Use only an extension cord recommended for outdoor use. Use
Toro's Cord Lock System to prevent the extension cord from
disconnecting from the machine.
If you do not fully seat the extension cord on the inlet
plug, the loose plug could lead to overheating and cause a
fire, possibly burning you or others.
Ensure that you fully seat the cord on the plug and use the
Toro's Cord Lock System to secure the cord.
Extension Cord Length
100 ft
150 ft
Note: Do not use an extension cord over 150 feet.
Figure 15
Important: Check the power cord frequently during use
for holes in the insulation. Do not use a damaged cord. Do
not run the cord through standing water or wet grass.
5
Minimum Wire Gage
(A.W.G.)
16
14