Safety/Warning - Loewe bild 2.49 Mode D'emploi


Loewe bild 2
Operating manual 2

Safety/Warning

Safety/Warning
For your safety, and to avoid unnecessary damage to your unit, please
read and follow the safety instructions below.
Key
This symbol indicates risks caused by high voltages.
This symbol indicates dangers caused by the development
of fire.
This symbol should alert the user to other, more specific risks.
This symbol indicates dangers caused by sharp edges.
Do not remove set rear panel
Warning: When opening or removing the rear panel, there is the danger
of electric shock and the risk of serious injury from high voltages.
ELECTRIC SHOCK DANGER–
Never open the rear panel yourself. Leave repairs and servicing work
on your TV set to qualified, authorised television technicians.
Please contact your dealer or our customer service.
Intended use and environmental conditions
This TV set is intended exclusively for the reception and
playback of picture and sound signals.
The TV set is designed for dry rooms (living rooms and office
spaces). It must not be used in rooms with a high level of
humidity (e.g. bathroom, sauna) or outdoors.
When using the set, make sure that it is protected from moisture
(dripping and splashing water or condensation).
High humidity and dust concentrations lead to power leaks in
the set. This can lead to danger of injury and damage to the set
by electric tensions or a fire.
If you've brought the set from the cold into a warm environment,
leave it off for around an hour due to the formation of
condensation.
Do not place objects filled with liquid on the
set. Protect the set from dripping and
splashing water.
Candles and other open flames must be
kept away from the set at all times, to pre-
vent the spread of fire.
37163000_OM2_bild_2_43-49_1_00_ML_Buch.indb 11 37163000_OM2_bild_2_43-49_1_00_ML_Buch.indb 11
ATTENTION
DO NOT OPEN
Transport
Improper handling during transportation can lead to damage
to the display and risks of injury.
The screen consists of glass or plastic and can break if handled
improperly.
Only transport the set in a vertical position.
No pressure should be applied to the glass or the plastic during
transport.
The correct handling is shown in the operating manual 1.
Do not place it on the lower edge so as to reduce the danger of
damage and contamination.
Mains cable/power supply
Incorrect voltages can damage the set.
This set may only be connected to a mains power supply with
the voltage and frequency indicated on the rating plate using
the enclosed mains cable.
The mains power plug of the TV set must be easily accessible
so that the set can be disconnected from the mains at any time.
When pulling the mains power plug out, do not pull the cable
but the plug housing. The cables in the mains power plug could
be damaged and cause a short circuit when plugged in again.
A mains power cable with a damaged insulation can lead to
electric shock and presents a fire hazard. Never use a damaged
mains cable.
Lay the mains cables so that they cannot be damaged. Do not
tread on the mains cable.
The mains cable must not be kinked or laid over sharp edges.
If you use a portable multiple socket to connect the TV set, do
not cascade several multiple sockets one behind the other.
Air circulation and high temperatures
Like any electronic device, your TV set requires air for cooling.
If air circulation is impeded, it may result in a fire.
The ventilation slots on the rear panel of
the set must therefore remain free.
Please do not cover the set.
Wall mounting: Leave at least 10 cm of
space all around the set at the side,
above and below.
Table / stand foot: Leave at least 10 cm
clear space around the set at the side
and at the top.
Foreign bodies
Foreign bodies inside of the set can lead to short circuits and
fires.
Danger of injury and damage exists
Therefore avoid metal parts, needles, paper clips, liquids, wax
or similar passing through the ventilation slits of the rear pan-
el into the interior of the set.
Should something get into the interior of the appliance, imme-
diately pull out the mains power plug of the set and inform the
customer service department for checking.
11
25.03.2019 08:13:45 25.03.2019 08:13:45