Removable front
access panel
Position fork lift
under pallet
Cable entrance knockouts
(2 per side)
Removable front
access panel
Position fork lift
under pallet
Cable entrance knockouts
(1 per side)
FIGURE 3
Typical Type 3R, CN1 to CN3 Ventilated Enclosure
Assembly for Three Phase and Single Phase Transformers.
Notes:
1. Handling - units are designed to be raised by a fork lift
from underneath the pallet. Final positioning of the unit
with the pallet removed can be via a hoist or forklift
mounted lifting attachment.
2. Shipping - units are shipped on pallets which are to be
removed at installation.
3. Installation - This transformer can be installed indoor or
outdoor providing a degree of protection against falling
rain, sleet and external ice formation.
4. All general purpose/drive isolation transformers should be
located away from any wall or any other obstruction,
please refer to the nameplate for the minimum distance.
5. DO NOT block bottom ventilation area
FIGURE 4
Typical Type 3R, CN4 to CN7 Series Ventilated Enclosure
Assembly for Three Phase or Single Phase Transformers.
Notes:
1. Handling - units are designed to be raised by a fork lift
from underneath the pallet. Final positioning of the unit
with the pallet removed can be via a fork lift under the
transformer with the forks between the channels. The
forks must extend out past the back of the unit and all
enclosure panels must be in place.
2. Shipping - units are shipped on pallets which are to be
removed at installation.
3. Installation - This transformer can be installed indoor or
outdoor providing a degree of protection against falling
rain, sleet and external ice formation.
4. All general purpose/drive isolation transformers should be
located away from any wall or any other obstruction,
please refer to the nameplate for the minimum distance.
(Note: These enclosures are not intended to be wall
mounted. They may be mounted on a customer supplied
platform.)
5. DO NOT block bottom ventilation area.
17
DIM16 / June 2019