Before To Ask For Service Assistance; Electric Diagram - Fiem libretto smart 2010 Manuel D'utilisation

8 . B E F O R E T O C A L L F O R S E R V I C E A S S I S TA N C E
Before to call the technical assistance, it is suitable to check the followings failures more common and ope-
rate in conformity.
PROBLEM
The machine does not work.
Low working temperature
Thermometer mercury column
interrupted
Automatic egg-turner
device does not work
Insufficient ventilation
It is severely forbidden any attempt of reparation of the machine, which is not between those suitable in the
aboveshow table, contact always technical assistance at the factory to the tel. 0039 031 / 97 66 72 ISND
fax. 031 / 89 91 63 – www.fiem.it - e-mails: fiem@fiem.it o incubators@fiem.it.
9.
ELECTRIC
DIAGRAM
16
CAUSE
Lack of power
Disconnected plug
Any of above points
Heating element bad working
Uncalibrated thermostat
Not or bad working thermostat
Room temperature under 18°C
Impacts, accidental drop
Lack of power
Plug disconnected
Egg-turner motor broken
Fan Motor does not work
: 76°C - 2A
SOLUTION
Check the plug
connect the plug
Contact the assistance service
Contact the builder
See the instruction for the calibration
Contact the builder
Place the incubator into a warm room
Try to expose the thermometer for few
minutes to low temperatures and then
in cold water otherwise substitute it
Check the plug
Put the plug into the socket
Contact the builder
Contact the builder